Planet WSW-2620 Manual page 46

Setting-Up for Management
Now it is necessary to restart the system so that the settings will take effect.
Press the Escape key to return to the Main Menu and select System Utility. In
the System Utility Menu, select System Restart. In the System Restart Menu
select Cold Start, then EXECUTE. Hit Enter to confirm Cold Start. Your
Switch will then restart and assign the new settings.
At this point, you should conduct a ping from the terminal you are using to
ensure that the IP address is assigned properly.
Note: If you had an Ethernet connection established when assigning the
IP address, the ping may be timed out. If this happens, simply
plug your Ethernet connection into a different port and conduct
another ping.
The Switch is now setup for management. The following chapter, "Console
Management," describes establishing a Telnet session and using the Console
management program.
System Restart
4-13