1-6.7.1 Prepare The M2488 Tape Drive; Figure 1-26. Prepare The M2488 Tape Drive - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE
1-6.7.1 Prepare the M2488 Tape Drive
Refer to Figure 1-26 during performance of this procedure.
STEP ACTION
1 Remove the bottom, and the left and right side covers. See Figure 8-7.
2 Remove the top cover by removing the two screws from the left and right side, and the two screws
on the rear. Pull the front of the cover up and slide backwards. See Figure 8-6.
3 Remove the four screws from the sides of the front panel, then gently pull the front panel forward.
4 Disconnect the operator panel cable from the front panel.
5 Remove the two screws holding the panel bracket, then pull off the panel bracket.
April 1997
****************
CAUTION
****************
Remove the top cover by lifting the front of the top cover BEFORE sliding it
backwards. Ensure that the cover does not catch on the components on the
PCBA under the top cover.

Figure 1-26. Prepare the M2488 Tape Drive

CG00000-011503 REV. A
INSTALLATION INSTRUCTIONS
1-33