4-3.24.3 Report Density Support Sense Keys - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE
4-3.24.3 REPORT DENSITY SUPPORT Sense Keys
One of the following sense keys may be returned if a CHECK CONDITION was indicated:
SENSE KEY CONDITION
2h NOT READY
3h MEDIUM ERROR
4h HARDWARE ERROR
5h ILLEGAL REQUEST
6h UNIT ATTENTION
April 1997
1. The Media bit is one and the logical unit is NOT READY.
1. Writing buffered data to tape failed due to defective tape.
2. An attempt was made to write 36-track data on 18-track format-
ted medium.
Write buffered data to tape failed due to a hardware error.
1. Reserved bit was found set in the CDB of the REPORT DEN-
SITY SUPPORT command.
2. The Flag bit was set but the Link bit was not set.
Indicates the REPORT DENSITY SUPPORT command was not
performed due to one of the following:
1. The tape cartridge may have been changed.
2. The target has been reset.
3. The Mode parameters have been changed by another initiator.
4. The version of the microcode has been changed (microcode
downloaded).
5. A cartridge was loaded with a tape length that is too long or too
short.
CG00000-011503 REV. A
TAPE UNIT SCSI COMMANDS
DESCRIPTION
4-111