INSTALLATION INSTRUCTIONS
1-6.5.3
Screw Plate Mounting
See Figure 1-14.
STEP
1
2
1-6.5.4
Attach Mounting Tray
See Figure 1-14.
NOTE: When the mounting hole of the rack is a screw hole, remove the positioning pins at both
the left and right sides of the tray (d) with a screwdriver.
STEP
1
2
3
1-20
Figure 1-13. Guide Plate Installation
ACTION
Each screw plate has nine holes. Mount the screw plate so that the big hole is up.
Attach 4 screw plates (g) to the rear of each pole of the rack with two screws (i -SBD-5x2S-M-
NI1A) in the top and bottom holes.
ACTION
Insert mounting tray (d) into the 19-inch rack and attach the front with six screws (j - SW2NA-
5x12S-M-NI1A).
Attach 2 brackets (f) to both the left and right sides of the tray (d) with six screws (k).
Attach brackets (f) to the left and right rear poles of the rack with eight screws (j) and tighten.
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
April 1997