Figure 8-11. Op Pcba; Op Pca Remove And Replace Procedures - Fujitsu M2488 Product Manual

MAINTENANCE AND SERVICING
8-11.9

OP PCA Remove and Replace Procedures

Refer to Figure 8-11 for location of the OP PCBA.
8-11.9.1 OP PCA Removal
STEP ACTION
1 Remove the four screws from the sides of the front panel.
2 Pull front panel forward and disconnect connector CNJ41.
3 Remove two screws from front panel.
4 Remove retaining plate and screw plate.
5 Remove two screws securing the OP PCA and remove the OP.
6 Remove the five switch buttons from the OP PCA.
8-11.9.2 OP PCA Replacement
STEP ACTION
1 Insert the five switch buttons into the OP PCA.
2 Secure the OP PCA to the front panel with two screws.
3 Insert screw plate and retaining plate.
4 Insert two screws into bottom of front panel.
5 Connect CNJ41. Push front panel onto drive.
6 Insert four side screws to secure front panel to drive.
8-52

Figure 8-11. OP PCBA

CG00000-011503 REV. A
M2488 PRODUCT GUIDE
April 1997