Table 8-23. Factory Menu Options And Settings Description - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE
Navigation keys:
To navigate through the options, settings, and to make changes from the Operator Panel:
Press START to move forward through the options or settings. It will also increment the setting num-
bers.
Press SHIFT and START to move backward through the options or settings. It will also decrement the
setting numbers.
Press RESET to move from settings to option or to leave setting mode.
Press TEST to move from the option to settings.
Press UNLOAD to select a number field for multiple digit numbers.
Setting Procedure:
Step 1. At the , press and hold the TEST and UNLOAD push-button simultaneously until DIAG-
MODE is displayed.
Step 2. Press the
pushed one time.
Step 2. Press the TEST pushbutton.
Step 3. The first option, F0:FACT0, is displayed. Press TEST will allow changing this setting if
the unit is in factory mode.
Step 4. Press the START push-button or SHIFT+START keys to select other factory options
described as follows:.
Table 8-23 describes the factory menu options and settings.

Table 8-23. Factory Menu Options and Settings Description

OPTION SETTINGS
F0:FMODE0 N/A
F1:FMODE1 N/A
F2:FMODE2 N/A
F3:FMODE3 N/A
F4:MTIME MTIME
F5:PTIME PTIME
F6:SRNUM SRNUM
F7:***** N/A
G8:FMODE DISABLE
ENABLE
G9: xxxxx N/A
G10:WTROM N/A
April 1997
push-button until FACTORY is displayed. Note:
START
DESCRIPTION
Factory mode setting 0 - presently not used.
Factory mode setting 1 - presently not used.
Factory mode setting 2 - presently not used.
Factory mode setting 3 - presently not used.
Tape motion time in seconds. Eight digit hexadecimal number.
Number of minutes the M2488 has been powered on. Eight digit
hexadecimal number.
Serial number of M2488 represented by 16 ASCII character string.
Unused factory setting menu item.
Factory mode is disabled. Press START key to move to ENABLE.
PW="?????" <-?
Press TEST,
Unused factory setting menu item.
Write to NVRAM the settings as changed. This menu item only
appears when Factory mode is enabled.
CG00000-011503 REV. A
MAINTENANCE AND SERVICING
+
SHIFT
is displayed.
may be
START
DEFAULT/
INITIAL
SETTINGS
00h
00h
00h
00h
00h
00h
SRNUM
N/A
N/A
N/A
8-29