Table F-12. Routine 10 - Edrc Control Signals Diagnostic Error Codes - Fujitsu M2488 Product Manual

M2488 PRODUCT GUIDE
Table F-11. Routine 9 - PCC Timers Diagnostic Error Codes (Continued)
ROUTINE TEST
0x03 PCC Timers Timer 2 test
0x09

Table F-12. Routine 10 - EDRC Control Signals Diagnostic Error Codes

ROUTINE TEST
0x10 * All R20 Control Check Diagnos-
tics
April 1997
ERROR
TITLE
CODE
0x02
0x03
0x04
ERROR
TITLE
CODE
0xD0
0xE0
0xE1
0xE2
0xE3
0xE4
0xE5
0xE6
0xE7
0xE8
0xE9
0x10
0x11
0x12
CG00000-011503 REV. A
DIAGNOSTIC TESTS AND ERROR CODES
DESCRIPTION
FMT counter 2 low count carry-out bit not set
Timer 2 running too FAST compared against
FMT counter 2.
Timer 2 running too SLOW compared against
FMT counter 2.
DESCRIPTION
SPC register initialization failed
SPC did not generate an interrupt request
SPC interrupt was not detected at the Interrupt
Request Controller
The SPC interrupt was cleared while clearing
the Interrupt Request Controller.
SPC interrupt/step code did not report Com-
mand Complete
The SPC interrupt request could not be
cleared
SPC did not generate an interrupt request
SPC interrupt was not detected at the Interrupt
Request Controller
The SPC interrupt was cleared while clearing
the Interrupt Request Controller.
SPC interrupt/step code did not report Diag-
nostic Self-Test passed
The SPC interrupt request could not be
cleared
At end of test, SPC did not generate an inter-
rupt request.
At end of test, SPC interrupt was not detected
at the Interrupt Request Controller.
At end of test, the SPC interrupt was cleared
while clearing the Interrupt Request Control-
ler.
F-25