8-7.2 Remote Debug For Jdb; 8-7.2.1 M2488 Side (Remote); 8-7.2.1.1 Equipment Required; Table 8-25. Maintenance Interface Communications Settings - Fujitsu M2488 Product Manual

MAINTENANCE AND SERVICING
To establish communications with this interface, host configuration settings for maintenance opera-
tions are provided in Table 8-25.

Table 8-25. Maintenance Interface Communications Settings

8-7.2 Remote Debug for JDB
These procedures describe how to establish a debug session between a local workstation and a remote
M2488.
8-7.2.1 M2488 Side (Remote)
8-7.2.1.1 Equipment Required
1 US Robotics Sportster 28,800 FAX Modem
1 RS-232 cable, 9-pin female to 25-pin male
1 M2488 Cartridge Tape Drive
8-7.2.1.2 Procedure
STEP ACTION
1 Switch M2488 power on. Wait for self-test diagnostics to complete. (The M2488 may already be
powered-on in which case you don't need to perform this step.)
2 Prepare modem DIP switch settings. Important settings are:
1 down (DTR override)
2 up (verbal results code)
3 up (suppress result codes)
4 up (echo off-line commands)
5 up (auto answer)
6 up (carrier detect normal)
7 down (load factory defaults)
8 down (smart modem)
3 Attach phone line to modem (telephone wall socket to modem connection.)
4 Attach line between phone and modem if desired.
5 Connect power cord to modem.
6 Connect RS-232 cable between modem and M2488.
7 Switch modem power on.
Press SHIFT and TEST keys at same time. Hold keys for 5 seconds. (If the modem has a Receive
8
Data (RD) lamp, this lamp will blink a few times.)
8-34
COMMUNICATIONS SETTING
BAUD rate
Parity
Data bits
Stop bits
Duplex
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
VALUE
19200
None
8
1
FULL
April 1997