Fujitsu M2488 Product Manual page 426

DIAGNOSTIC TESTS AND ERROR CODES
Table F-12. Routine 10 - EDRC Control Signals Diagnostic Error Codes (Continued)
ROUTINE TEST
* All R20 Control Check Diagnos-
0x10
tics
0x10 0x01 Write clear 3 bytes 00, mode 1Eh
0x10 0x02 Read clear 3 bytes 00, mode 0Eh
F-26
ERROR
TITLE
CODE
0x13
0x14
0xEF
0x01
0x02
0x03
0x04
0x05
0x06
0x07
0x01
0x02
0x03
0x04
CG00000-011503 REV. A
M2488 PRODUCT GUIDE
DESCRIPTION
At end of test, SPC interrupt/step code did not
report Command Complete.
At end of test, the SPC interrupt request could
not be cleared.
SPC interrupt request or interrupt/step register
could not be cleared at the end of the test
after a write diag operation was initialized in
the spc chip, the SPC-status register did not
have one of the following:
SPC_data_trans_rdy, SPC_busy, or
SPC_data_reg_empty.
when transferring data from the SPC send
buffer to the SPC data fifo, the SPC-ssig regis-
ter did not have the expected bits set:
SCSI_REQ, SCSI_BSY, xfer_phase.
when transferring data from the SPC send
buffer to the SPC data fifo, the SPC-ssig regis-
ter did not have the expected bits set:
~SCSI_REQ, SCSI_ACK, SCSI_BSY,
xfer_phase.
A non SUCCESS status was returned from
the function call rm_request_wrtbuffer.
All the data expected to be transferred out of
the SPC data fifo was not transferred to the
SDDP.
A non SUCCESS status was returned from
the function call rm_host_wrt_cmplt. A error
was detected in the SDDP_HI-hdxs register.
A byte for byte miscompare was detected on
the data bytes stored in the data_buffer.
A host data path end of transfer was not
detected in the allotted time.
when transferring data from the SPC data_fifo
to the SPC receive_buffer, the SPC-ssig regis-
ter did not have the expected bits set:
SCSI_REQ, SCSI_BSY, xfer_phase.
when transferring data from the SPC data_fifo
to the SPC receive_buffer, the SPC-ssig regis-
ter did not have the expected bits set:
~SCSI_REQ, SCSI_ACK, SCSI_BSY,
xfer_phase.
All the data expected to be transferred from
the SPC data_fifo to the SPC receive_buffer
was not transferred.
April 1997