Virtual Lan (Vlan) Commands - Dell PowerEdge M I/O Aggregator Reference Manual

Virtual LAN (VLAN) Commands

The following commands configure and monitor virtual local area networks (VLANs). VLANs are a
virtual interface and use many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP,
TFTP, ACLs, and SNMP are not supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the virtual router
redundancy protocol (VRRP) state of a VLAN interface may continually switch between Master and
Backup.
•
•
•
•
•
•
•
auto vlan
Change the port to auto or admin vlan mode (enable or disable all auto VLANs).
Syntax auto vlan <cr>
To remove membership from 4K VLAN, use the no auto vlan command.
Parameters
description
Defaults none
Command Modes
INTERFACE
Usage The auto vlan command adds the port as untagged to default vlan and tagged to all other 4K-1 VLAN.
Information
Command
Version 8.3.17.0
History
clear counters
Clear the counters used in the show interfaces commands for all VRRP groups, VLANs, and physical
interfaces, or selected ones.
Syntax
clear counters interface
auto vlan
default vlan-id
name
show config (from INTERFACE VLAN mode)
show vlan
vlan tagged
vlan untagged
Enter a text string description to identify the VLAN (80 characters maximum).
Supported on M I/O Aggregator
Interfaces | 129