Show Ip Igmp Groups - Dell S6100 Configuration Manual

show ip igmp groups

View the IGMP groups.
Syntax show ip igmp [vrf vrf-name] groups [group-address [detail] | detail | interface
[group-address [detail]]]
Parameters
vrf vrf-name
group-address
interface
detail
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this
setting on that VRF.
(OPTIONAL) Enter the group address in dotted decimal format to view information on
that group only.
(OPTIONAL) Enter the interface type and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
(OPTIONAL) Enter the keyword detail to display the IGMPv3 source information.
EXEC
EXEC Privilege
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Internet Group Management Protocol (IGMP) 647