Telephone Base Basic Operation - AT&T SB67118 Getting Started

Telephone base operation

Telephone base basic operation

The phone comes programmed to use line 1 (default primary line) for calls
when you do not press a line key. (To change the primary line, see
Line Selection on page X of the installation guide.) When you answer a call,
the phone automatically selects the ringing line.
Lit line indicators
The four indicators on the LINE keys indicate the state of the corresponding
phone line.
The four LINE indicator lights are green:
• On when the corresponding line is in use.
• Flashes slowly when the line is on hold.
• Flashes rapidly when there is an incoming call on the corresponding line.
• Flashes rapidly when there is a transferred call on the corresponding line.
• Flashes rapidly when there is an incoming auto attendant transferred call
on the corresponding line.
Making a call
• To make a call:
1. Lift the handset or press
-OR-
To override automatic line selection, press the LINE (1-4) key for the
desired line, then lift the handset.
2. Wait for a dial tone, then enter the telephone number
and the screen displays the elapsed time as you talk (in
hours, minutes and seconds).
• To end a call:
Place the handset on the telephone base to hang up.
-OR-
If you are using speaker phone, press
NOTE: The elapsed time is not affected by accessing services from your local telephone service
provider.
SPEAKER.
SPEAKER to hang up.
37
On
Elapsed time
Line 1 00:00:27
1234567