Telephone Base Operation; Telephone Base Basic Operation; Line Indicators; Making A Call - AT&T SB67108 - User Manual

Telephone base operation

Telephone base basic operation

The telephone comes programmed to use line 1 (default primary line) for
calls when you do not press a line key. (To change the primary line, see
Line selection on page 19.) When you answer a call, the telephone
automatically selects the ringing line.

Line indicators

Each of the four indicators on LINE 1-LINE 4 indicate the state of the
corresponding telephone line.
• On when the corresponding line is in use.
• Flashes slowly when the line is on hold.
• Flashes slowly when there is a transferred call on the corresponding line.
• Flashes slowly when there is an incoming auto attendant transferred call
on the corresponding line.
• Flashes rapidly when there is an incoming call on the corresponding line.

Making a call

To make a call from the telephone base:
1. Lift the handset or press
-OR-
To override automatic line selection, press LINE 1-LINE 4 for the desired
line, then lift the handset.
2. Wait for a dial tone, then enter the telephone number.
The screen displays the elapsed time as you talk
(in hours, minutes and seconds).
To end a call from the telephone base:
Place the handset on the telephone base to hang up.
-OR-
If you are using the speakerphone, press
NOTE: The elapsed time is not affected by accessing services from your telephone service provider.
SPEAKER.
40
Line1
8888832445
SPEAKER to hang up.
Elapsed time
00:00:27