External Inputs: Using A Balanced Driver; Output Signals Electrical Specifications; External Output Details And Dc Characteristics - Teledyne m640 User Manual

External Inputs: Using a Balanced Driver

Warning: Only one External Signal can be used (input 1 or input 2).
•

Output Signals Electrical Specifications

External Outputs Block Diagram
Output Common Power

External Output Details and DC Characteristics

Programmable output mode such as strobe, event notification, etc
•
(see outputLineSource
Outputs are open on power-up with the default factory settings
•
A software reset will not reset the outputs to the open state if the outputs are closed
•
• A user setup configured to load on boot will not reset the outputs to the open state if the
outputs are closed
• No output signal glitch on power-up or polarity reversal
Typical Operating Common Power Voltage Range: +3V to 28Vdc at 24mA
•
Maximum Common Power Voltage Range : ±30Vdc
•
Maximum Output Current: 36mA
•
Nano Series GigE Vision Camera
Camera IO
Interface
10 9
( Input 2 )
8 7
( Input 1 )
6 5
( Common Ground )
4 3
2 1
(pin 4)
Output 2 (pin 8)
Output 1 (pin 6)
feature)
RS-422
Compatible
Transmitter
!
Only one Input can be used
in this configuration.
Current
Protection
Limiter
Current
Protection
Limiter
External Signal
Technical Specifications • 195