Camera Dc Power Characteristics; I/O Mating Connector Sources; Power Over Ethernet (Poe) Support - Teledyne m640 User Manual

Camera DC Power Characteristics

DC Operating Characteristics
Input Voltage
Input Power Consumption
Input Power Consumption
Input Power Consumption
Absolute Maximum DC Power Supply Range before Possible Device Failure
Input Voltage

I/O Mating Connector Sources

For users wishing to build their own custom I/O cabling, the following product information is
provided to expedite your cable solutions.
MFG Part #
Samtec SFSD-05-[WG]-G-[AL]-DR-[E2O]
WG : Wire Gauge
AL : Assembled Length
E2O : End 2 Option
Samtec ISDF-05-D
ISDF-05-D-M
ISDF-05-D-M Connector Availability On-Line
North-America (specific country can be selected)
Europe (specific country can be selected)
Asia-Pacific (specific country can be selected)
Important: Samtec ISDF-05-D-S is not compatible with Genie Nano

Power over Ethernet (PoE) Support

The Genie Nano requires a PoE Class 0 or Class 2 (or greater) power source for the network if
•
not using a separate external power source connected to pins 1 & 2 of the camera's I/O
Connector.
To use PoE, the camera network setup requires a powered computer NIC supporting PoE, or a
•
PoE capable Ethernet switch, or an Ethernet power injector.
Important: Connect power via the I/O connector or PoE, but not both. Although Nano has
•
protection, differences in ground levels may cause operational issues or electrical faults.
If both supplies are connected and active, the Nano will use the I/O power supply connector.
•
But as stated, ground differences may cause camera faults or failure.
Important: When using PoE, the camera's I/O pin 1 (Camera Power – Ground) must not be
•
connected to I/O pin 3 (General Input Common Ground).
Nano Series GigE Vision Camera
+10 Volts minimum
@ +12 Volt Supply
@ +24 Volt Supply
@ +48 Volt Supply
–58 Volt DC
Description Data Sheet
Discrete Cable www.samtec.com/technical-
Assembly specifications/Default.aspx?SeriesMaster=SFSD
Discrete www.samtec.com/technical-
Connector specifications/Default.aspx?SeriesMaster=ISDF
http://www.newark.com/samtec/isd2-05-d-m/connector-housing-
10pos-2mm/dp/84T0350
http://uk.farnell.com/samtec/isdf-05-d-m/receptacle-1-27mm-crimp-
10way/dp/2308547?ost=ISDF-05-D-M
http://sg.element14.com/samtec/isdf-05-d-m/receptacle-1-27mm-
crimp-10way/dp/2308547?ost=ISDF-05-D-M
3.99 Watts typical
3.96 Watts typical
4.22 Watts typical
+58 Volts DC
Technical Specifications • 191