Cycling Preset Mode Control Feature Description - Teledyne m640 User Manual

Cycling Preset Mode Control Feature Description

The following table describes these features along with their view attribute and device framework version. For each feature the device version
may differ for each camera sensor available. Such differences will be clearly indicated for any applicable feature.
As Genie Nano capabilities evolve the device firmware version will increase, therefore identifying the supported function package. New
features for a major device version release will be indicated by
The first column indicates whether a feature applies to monochrome or color camera models via a symbol. No symbol indicates a common
feature. Additionally the description column will indicate which feature is a member of the Teledyne DALSA Features Naming Convention
(denoted by DFNC), versus the GenICam Standard Features Naming Convention (SFNC not shown).
B/W Display Name
Color
Cycling Preset Mode
Cycling Preset Count
Cycling Preset Incremental
Source
Valid Frame Trigger
Counter 1 End
Start of Frame
Trigger Input Line Activation
Rising Edge
Falling Edge
Any Edge
116 • Operational Reference
Feature & Values
cyclingPresetMode
Off
Active
cyclingPresetCount
cyclingPresetIncrementalSource
None
ValidFrameTrigger
Counter1End
StartOfFrame
Line2
cyclingPresetIncrementalActivation
green text for easy identification.
Description
Sets the Cycling Presets module mode.
< Expert, DFNC >
Note: not available on rolling shutter model C4900
Off Disable the Cycling Preset module.
Active Enable the Cycling Preset module.
Specifies the number of Presets to use.
< Expert, DFNC >
Specifies the source that increments the currently active
cycling preset.
< Expert, DFNC >
None Feature cyclingPresetCurrentActiveSet is used to select
the current active set.
Increment on a Valid Frame Trigger
Increment on the end of Counter 1.
Increment on the Start of Frame event
Line2 Select Line 2 (and associated I/O control block) to use as
the external increment source.
Select the activation mode for the selected Input Line
source. This is applicable only for external line inputs.
< Expert, DFNC >
RisingEdge The source is considered valid on the rising edge of the
line source signal (after being process by the line inverter
feature).
FallingEdge The source is considered valid on the falling edge of the
line source signal (after being process by the line inverter
feature).
AnyEdge The source is considered valid on any edge (falling or
rising) of the line source signal (after being process by
the line inverter feature).
Sony OnSemi
Sensors Sensors
Ver. 1.01 Ver. 1.00
Ver. 1.01
Ver. 1.01
Ver. 1.01
Nano Series GigE Vision Camera