Gige Vision Host Control Category; Teledyne Dalsa Turbodrive; File Access Control Category - Teledyne m640 User Manual

GigE Vision Host Control Category

The GigE Vision Host controls, as shown by CamExpert, groups parameters used to configure the
host computer system GigE Vision features used for Genie Nano networking management. None of
these parameters are stored in any Genie Nano camera.
These features allow optimizing the network configuration for maximum Nano bandwidth. Settings
for these parameters are highly dependent on the number of cameras connected to a NIC, the data
rate of each camera and the trigger modes used.
Information on these features is found in the Teledyne DALSA Network Imaging Module User
manual.

Teledyne DALSA TurboDrive

For Genie Nano cameras supporting TurboDrive, ensure to set the feature "Turbo Transfer Mode"
to True.

File Access Control Category

The File Access control in CamExpert allows the user to quickly upload various data files to the
connected Genie Nano. The supported data files are for firmware updates, and dependent on the
Nano model, LUT tables, Defective Pixel Maps, and other Sapera file types.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications.
Also important, Genie Nano cameras are available in a number of models implementing different
sensors and image resolutions which may not support the full feature set defined in this category.
178 • Operational Reference
Nano Series GigE Vision Camera