Connectors; 10-Pin I/O Connector Details - Teledyne m640 User Manual

Connectors

A single RJ45 Ethernet connector for control and video data to the host Gigabit NIC.
•
Additionally for PoE, the Genie Nano requires an appropriate PoE Class 0 or Class 3 (or greater)
power source device (such as a powered computer NIC, or a powered Ethernet switch, or an
Ethernet power injector). For industrial environments, Nano supports the use of screw lock
Ethernet cables (see "Ruggedized RJ45 Ethernet
installations, a shielded Ethernet cable is required to provide a camera ground connection to the
controlling computer.
A single 10-pin connector (SAMTEC TFM-105-02-L-D-WT) for all Genie Nano I/O and an
•
auxiliary DC power source. Nano supports connecting cables with retention latches or screw
locks. The following figure shows pin number assignment.
Note: Connect power via the I/O or PoE, not both. Although Nano has protection, differences in
•
ground levels may cause operational issues or electrical faults.

10-pin I/O Connector Details

Teledyne DALSA makes available optional I/O cables as described in Accessories. Contact Sales for
availability and pricing.
Pin Number Genie Nano
1
2
3 GPI-Common
4 GPO-Power
5
6
7
8
9
10
‡ Note: "G3-GM2... or G3-GC2..." part numbers denote optional "1 input / 3 output" special order
models. Output 3 only supports Software Controlled logic High or Low signals. See
Characteristics: "1 input / 3 output" Models
190 • Technical Specifications
Direction
PWR-GND
PWR-VCC
GPI 1
GPO 1
GPI 2
Reserved
GPO 2
Reserved
GPO 3
Chassis
Cables" on page
Definition
— Camera Power – Ground
— Camera Power – DC +10 to +36 Volts
— General Input Common Ground
— General Output Common Power
In General External Input 1
Out General External Output 1
In General External Input 2
— N/A for G3-Gx2
Out General External Output 2
Out General External Output 3 for
Camera Chassis
for additional information.
226). Note that for PoE
... models ‡
... models ‡
G3-Gx2
AC
Nano Series GigE Vision Camera