Adjustment Of Fs-113 Elevator Tray Overload Detection Level - Konica Minolta 7145 Service Manual
Hide thumbs
Also See for 7145:
- Internet fax / fax operations (453 pages) ,
- Service manual (448 pages) ,
- Instruction manual (324 pages)
Table of Contents
Advertisement
7145 series Field Service Ver.4.0 Mar. 2004
10.13Adjustment of FS-113 Eleva-
tor Tray Overload Detection
Level
• This adjustment must be made when the Control
Board (PWB-A) or the Elevator Motor (M7) is
replaced with a new one.
A. Procedure
1. Set the "Elevator Tray operation" function of the
Test Mode.
2. Turn VR2 on PWB-A fully counterclockwise.
3. Using a sheet of paper, block the Elevator Tray
Upper Limit Sensor LED (PWB-C). Then using
the "Elevator Tray operation" function, lower the
Elevator Tray.
4. Place 1,500 sheets of A3 (80g/m
sheets of A4 (80g/m
Tray.
5. Using the "Elevator Tray operation" function,
raise the Elevator Tray.
6. While the Elevator Tray is going up, turn VR2 on
PWB-A clockwise and, when LED3 on PWB-A
turns from a steady light to off, stop turning VR2.
2
) or 3,000
2
) paper on the Elevator
1-107
OTHER ADJUSTMENTS
Advertisement
Table of Contents
