Konica Minolta 7145 Service Manual page 54

25 MODE
*
7 Setting of the polygon motor for stopping or
low speed rotation
In order to reduce the sound of rotation of the
polygon motor while in idling, it is possible to
switch the rotation of the polygon motor either
to a low speed rotation or stopping. The timing
for the switching is set based on
the polygon motor to stop/start a low speed
rotation. When the polygon motor is stopped
or rotating at low speed, the time required for
the first copy being made is increased.
Mode
No preliminary rotation
(high speed)
Preliminary rotation
(low speed)
Stopping
*
8 Out-of-original auto erasure
When the AMS has been released due to the
original size being not the same as that of the
transfer paper size, this setting is used in the
platen copy to decide whether the out-of-origi-
nal area is erased or not. This is the same
function as the memory switch function in the
key operator mode. (Switching is not available
in the RADF copy mode.)
Mode
Out-of-original auto erasure
Out-of-original erasure only while in
APS/AMS
*
9 Automatic re-starting after paper supply
(excluding inch system)
Mode
Re-starting by turning on the START
button
Re-starting by setting the tray (auto-
matic)
*
6 Timing for
6-7 6-6
0 0
0 1
1 0
7-0
0
1
7-1
0
1
1-24
7145 series Field Service Ver.4.0 Mar. 2004
*
10 Automatic conversion of the APS detected
paper size (8.5 x 11/A4)
The paper size detected by the APS is auto-
matically converted according to the standard
shown below before being copied.
Mode
No automatic conversion
A4 → 8.5 x 11 (Inch)
8.5 x 11 → A4 (Japan, Metric)
*
11 Switching of non-standard size notice of
platen APSA4 (Japan/Metric), 8.5 x 11 (inch)
When the original size is detected as a non-
standard size, the switching is made to decide
a copying method: a copy is made forcibly into
the following size or it is made in the size
selected as a non-standard size.
When both the DIPSW 7-3 and 7-4 are 1, the
DIPSW7-4 has preference over 7-3.
Mode
Copied in the size selected
Copied forcibly as A4 (Japan, Metric)
/8.5 x 11 (Inch)
Mode
Copied in the size selected
Copied forcibly as B6 (Japan)
/A5 (Metric)/5.5 x 8.5 (Inch)
*
12 Priority tray when APS is released
This setting sets the tray selection used when
APS is set OFF from key-operator mode.
Mode
No priority
Main-body upper tray
Main-body lower tray
DB upper tray
DB lower tray
7-2
0
1
7-3
0
1
7-4
0
1
8-6 8-5 8-4
0 0 0
0 0 1
0 1 0
0 1 1
1 0 0