Konica Minolta 7145 Service Manual page 123

7145 series Field Service Ver.4.0 Mar. 2004
3. When the skew is not up to the standards, open
the open/close cover[1] and remove the 2 cov-
ers[2].
4. Loosen the hexagon nut[3], and rotate the set
screw[4] to adjust the clearance of the guide
plate.
• A: Loosen the hexagon nut[3] at the rear and
rotate the set screw[4] clockwise.
• B: Loosen the hexagon nut[3] at the front and
rotate the set screw[4] clockwise.
Note:
• Since there is the possibility of jamming, be sure
not make the clearance of the guide plate nar-
rower than the standard value. (Be sure not to
tighten the hexagon nut [3].)
• The reference value of the clearance of the guide
plate should be determined based on the position
where the difference in level[A] of the second
stage of the clearance reference block[5]
becomes flush with the metal frame surface[B].
5. Repeat the steps 1 to 4 until the original skew
gets within the standard value.
[1]
1-93
OTHER ADJUSTMENTS
[5]
[2]
[2]
[3]
[4]