Juniper EX9200 Features Manual page 91

Purpose
Action
Purpose
Action
Copyright © 2016, Juniper Networks, Inc.
Policers:
Name
p-all-1m-5k-discard-fe-0/1/1.1-inet-i
Displaying the Policers and Firewall Filters Applied to an Interface
Verify that the firewall filter
logical interface .
fe-0/1/1.1
Use the show interfaces statistics
, and include the
fe-0/1/1.1 detail
output section, the Input Filters and Policer lines display the names of filter and policer
applied to the logical interface in the input direction.
user@host> show interfaces statistics fe-0/1/1.1 detail
Logical interface fe-0/1/1.1 (Index 83) (SNMP ifIndex 545) (Generation 153)
Flags: SNMP-Traps 0x4000 VLAN-Tag [ 0x8100.100 ]
Traffic statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Local statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Protocol inet, MTU: 1500, Generation: 176, Route table: 0
Flags: Sendbcast-pkt-to-re
Input Filters: filter-ipv4-with-limits-fe-0/1/1.1-i
Policer: Input: p-all-1m-5k-discard-fe-0/1/1.1-inet-i
Addresses, Flags: Is-Preferred Is-Primary
Destination: 10.20.130/24, Local: 10.20.130.1, Broadcast: 10.20.130.255,
Generation: 169
In this example, the two firewall filter policers are applied to logical interface traffic in
the input direction only.
Displaying Statistics for the Firewall Filter Policers
Verify the number of packets evaluated by the firewall filter policers.
Use the show firewall operational mode command for the filter you applied to the logical
interface.
[edit]
user@host> show firewall filter filter-ipv4-with-limits-fe-0/1/1.1-i
Filter: filter-ipv4-with-limits-fe-0/1/1.1-i
Chapter 7: Basic Single-Rate Two-Color Policers
filter-ipv4-with-limits is applied to the IPv4 input traffic at
operational mode command for logical interface
option. Under the Protocol inet section of the command
0
46
0
1
0
46
0
1
0
0
0
0
Bytes Packets
200
Encapsulation: ENET2
0 bps
0 bps
0 pps
0 pps
5
73