Juniper EX9200 Features Manual page 79

Step-by-Step
Procedure
Results
Copyright © 2016, Juniper Networks, Inc.
To configure Device R2:
Configure the device interfaces.
1.
[edit interfaces]
user@R1# set ge-2/0/8 description to-R1
user@R1# set ge-2/0/7 description to-Host
user@R1# set lo0 unit 0 description looback-interface
user@R1# set ge-2/0/8 unit 0 family inet address 10.50.0.2/30
user@R1# set ge-2/0/7 unit 0 family inet address 172.16.80.2/30
user@R1# set lo0 unit 0 family inet address 192.168.14.1/32
Configure OSPF.
2.
[edit protocols ospf]
user@R1# set area 0.0.0.0 interface ge-2/0/7.0 passive
user@R1# set area 0.0.0.0 interface lo0.0 passive
user@R1# set area 0.0.0.0 interface ge-2/0/8.0
From configuration mode, confirm your configuration by entering the
, and
show firewall show protocols ospf
intended configuration, repeat the instructions in this example to correct the configuration.
user@R1# show interfaces
ge-2/0/5 {
description to-Host;
unit 0 {
family inet {
filter {
input mf-classifier;
}
address 172.16.70.2/30;
}
}
}
ge-2/0/8 {
description to-R2;
unit 0 {
family inet {
address 10.50.0.1/30;
}
}
}
lo0 {
unit 0 {
description looback-interface;
family inet {
address 192.168.13.1/32;
}
}
}
user@R1# show firewall
family inet {
filter mf-classifier {
term t1 {
Chapter 7: Basic Single-Rate Two-Color Policers
commands. If the output does not display the
,
show interfaces
61