Juniper EX9200 Features Manual page 101

Purpose
Action
Related
Documentation
Copyright © 2016, Juniper Networks, Inc.
Transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Protocol inet, MTU: 1500, Generation: 175, Route table: 0
Flags: Sendbcast-pkt-to-re
Policer: Input: LB-policer-ge-1/3/0.1-inet-i, Output:
LB-policer-ge-1/3/0.1-inet-o
Addresses, Flags: Is-Preferred Is-Primary
Destination: 172.17.1.0/30, Local: 172.17.1.1, Broadcast: 172.17.1.3,
Generation: 167
Displaying Statistics for the Policer
Verify the number of packets evaluated by the policer.
Use the operational mode command and optionally specify the name of
show policer
the policer. The command output displays the number of packets evaluated by each
configured policer (or the specified policer), in each direction. For the policer
the input and output policer names are displayed as follows:
LB-policer-ge-1/3/0.0-inet-i
LB-policer-ge-1/3/0.0-inet-o
LB-policer-ge-1/3/0.1-inet-i
LB-policer-ge-1/3/0.1-inet-o
The -inet-i suffix denotes a policer applied to logical interface input traffic, while the
-inet-o suffix denotes a policer applied to logical interface output traffic. In this example,
the policer is applied to both input and output traffic on logical interface
logical interface
ge-1/3/0.1
user@host> show policer
Policers:
Name
__default_arp_policer__
LB-policer-ge-1/3/0.0-inet-i
LB-policer-ge-1/3/0.0-inet-o
LB-policer-ge-1/3/0.1-inet-i
LB-policer-ge-1/3/0.1-inet-o
Two-Color Policer Configuration Overview on page 49
Bandwidth Policer Overview on page 75
bandwidth-percent on page 201
interface-specific
logical-bandwidth-policer on page 221
shaping-rate (Applying to an Interface)
0
0
0
0
.
Chapter 8: Bandwidth Policers
0 bps
0 bps
0 pps
0 pps
LB-policer
ge-1/3/0.0
Packets
0
0
0
0
0
,
and
83