Juniper EX9200 Features Manual page 176

Traffic Policers Feature Guide for EX9200 Switches
Results
Verification
Purpose
Action
158
Reference the filter as an input filter.
4.
[edit interfaces ge-2/0/5 unit 0 family inet]
user@host# set filter input filter-srtcm1ca-all
Confirm the configuration of the interface by entering the
configuration mode commands. If the command output does not display the
interfaces
intended configuration, repeat the instructions in this procedure to correct the
configuration.
[edit]
user@host# show class-of-service
interfaces {
ge-2/0/5 {
unit 0 {
forwarding-class af;
}
}
}
[edit]
user@host# show interfaces
ge-2/0/5 {
unit 0 {
family inet {
filter {
input filter-srtcm1ca-all;
}
address 10.20.130.1/24;
}
}
}
If you are done configuring the device, enter
Confirm that the configuration is working properly.
Displaying the Firewall Filters Applied to the Logical Interface
Verify that the firewall filter is applied to IPv4 input traffic at the logical interface.
Use the operational mode command for the logical interface
show interfaces
and specify mode. The Protocol inet section of the command output displays IPv4
detail
information for the logical interface. Within that section, the Input Filters field displays
the name of the firewall filter applied to IPv4 input traffic at the logical interface.
user@host> show interfaces ge-2/0/5.0 detail
Logical interface ge-2/0/5.0 (Index 105) (SNMP ifIndex 556) (Generation 170)
Flags: Device-Down SNMP-Traps 0x4004000 Encapsulation: ENET2
Traffic statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Local statistics:
show class-of-service
from configuration mode.
commit
0
0
0
0
Copyright © 2016, Juniper Networks, Inc.
and
show
,
ge-2/0/5.0