Juniper EX9200 Features Manual page 41

Copyright © 2017, Juniper Networks, Inc.
a. Configure the first Virtual Chassis port that connects to member 0.
{master:member1-re0}
user@hostB> request virtual-chassis vc-port set fpc-slot fpc-slot-number pic-slot
pic-slot-number port port-number
b. When the first Virtual Chassis port is up on member 1, repeat Step 2a to configure
the second Virtual Chassis port that connects to member 0.
{master:member1-re0}
user@hostB> request virtual-chassis vc-port set fpc-slot fpc-slot-number pic-slot
pic-slot-number port port-number
When all of the line cards in all of the member routers or switches are online, and the
Virtual Chassis has formed, you can issue Virtual Chassis commands from the terminal
window of the master router or switch.
NOTE: When the Virtual Chassis forms, the FPC slots are renumbered to
reflect the slot numbering and offsets used in the Virtual Chassis instead
of the physical slot numbers where the FPC is actually installed. Member
0 in the Virtual Chassis uses FPC slot numbers 0 through 11 with no offset,
and member 1 uses FPC slot numbers 12 through 23, with an offset of 12.
For example, a 10-Gigabit Ethernet interface that appears as
(FPC slot 14, PIC slot 2, port 2) in the
actually interface
after deducting the FPC slot numbering offset of 12 for member 1.
(Optional) Verify the that the Virtual Chassis is properly configured and that the Virtual
3.
Chassis ports are operational.
{master:member0-re0}
user@hostA> show virtual-chassis status
{master:member0-re0}
user@hostA> show virtual-chassis vc-port all-members
Commit the configuration on the master router or switch.
4.
The commit step is required to ensure that the configuration groups and Virtual Chassis
configuration are propagated to both members of the Virtual Chassis.
BEST PRACTICE:
command to save any configuration changes to the Virtual Chassis.
For an MX Series or Virtual Chassis, the
behavior when you issue the
commit synchronize
show interfaces
(FPC slot 2, PIC slot 2, port 2) on member 1
xe-2/2/2
We recommend that you use the
force
commit synchronize
command for an MX Series Virtual Chassis
Chapter 3: Virtual Chassis Ports
xe-14/2/2
command output is
commit synchronize
option is the default and only
command. Issuing the
41