Juniper EX9200 Features Manual page 35

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
one Routing Engine on the switch or the request system reboot both-routing-engines
command to reboot both Routing Engines simultaneously.
Log back onto member 0 after the reboot is complete. Configure the interfaces that
9.
you want to configure as VCPs as VCPs:
user@switch-0>request virtual-chassis vc-port set fpc-slot fpc-slot-number pic-slot
pic-slot-number port port-number
NOTE: A VCP is not created until the request virtual-chassis vc-port set
command is enabled on the interfaces on the member switches at both
ends of the link.
The request virtual-chassis vc-port set is enabled on the interface on the
other end of the link in step
For instance, you can configure port 0 on PIC slot 1 in FPC slot 1 as a VCP using the
following command:
user@switch-0> request virtual-chassis vc-port set fpc-slot 1 pic-slot 1 port 0
vc-port successfully set
Log back onto member 1 after the reboot is complete. Configure the interfaces that
10.
you want to configure as VCPs:
user@switch-0>request virtual-chassis vc-port set fpc-slot fpc-slot-number pic-slot
pic-slot-number port port-number
NOTE: You can configure multiple links into VCPs. If you configure
interfaces of the same speed between the member switches into the
VCPs, the VCPs automatically form a Link Aggregation group (LAG) bundle.
You can use the show virtual-chassis vc-port
You can use the
show virtual-chassis
Deleting Member IDs in a Virtual Chassis Configuration on page 49
Deleting Virtual Chassis Ports in a Virtual Chassis Configuration on page 42
Configuring Virtual Chassis Ports to Interconnect Member Routers or Switches on
page 40
Creating and Applying Configuration Groups for a Virtual Chassis on page 36
Chapter 2: Accessing and Configuring a Virtual Chassis and Managing Files
10 to complete the VCP configuration process.
command to verify that a VCP is created.
command to verify Virtual Chassis status.
35