Request Virtual-Chassis Vc-Port - Juniper EX9200 Features Manual

Virtual chassis feature guide ex series
Hide thumbs Also See for EX9200:
Table of Contents

Advertisement

request virtual-chassis vc-port

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
request virtual-chassis vc-port [set | delete] <fpc-slot fpc-slot> pic-slot pic-slot port
port-number <member member-id>
Command introduced in Junos OS Release 9.0 for EX Series switches.
Option
fpc-slot
introduced in Junos OS Release 10.4 for EX Series switches.
Command introduced in Junos OS Release 13.2X50-D15 for the QFX Series.
Command introduced in Junos OS Release 13.2X51-D20 for Virtual Chassis Fabric (VCF).
Enable or disable an optical port as a Virtual Chassis port (VCP).
If you omit
member member-id
VCP or SFP network port configured as a VCP on the switch where the command is
issued.
You might experience a temporary traffic disruption immediately after creating or deleting
a user-configured VCP in an EX8200 Virtual Chassis.
NOTE:
Some EX Series switches have ports that are configured as VCPs by
default. You do not need to explicitly configure those ports as VCPs to use
them to interconnect the switch into a Virtual Chassis. See
EX Series Virtual Chassis Components" on page 16
—Set a network port as a VCP to convert a network port into a VCP.
set
—Delete the VCP setting on a port to convert a VCP into a network port.
delete
—Number of the PIC slot for the port on the switch.
pic-slot pic-slot
—Number of the port that is to be enabled or disabled as a VCP.
port port-number
member member-id
—(Optional) Enable or disable the specified VCP on the specified
member of the Virtual Chassis or VCF.
system-control
request virtual-chassis vc-port (dedicated port)
show virtual-chassis vc-port on page 149
show virtual-chassis vc-port statistics
clear virtual-chassis vc-port statistics
Virtual Chassis Port (VCP) Interface Names in an EX8200 Virtual Chassis
Chapter 12: Operational Commands: Administrative
, this command defaults to enabling or disabling the uplink
"Understanding
for details.
113

Advertisement

Table of Contents
loading

Table of Contents