Mitsubishi Electric MR-J3-B-RJ006 Instruction Manual page 81

3. LOAD SIDE ENCODER
(4) Load side encoder cable
(a) For LC491M or LC192M (Absolute type)
1) Cable structure
Prepare a cable based on the following structure diagram.
Servo amplifier
CN2L
When using an 1) Option manufactured by Heidenhain Corporation
optional cable (This should be prepared by the customer.) (Note)
When producing 2) Connector set MR-J3CN2
a load side (Option manufactured by
encoder cable Mitsubishi Electric
Corporation)
(Refer to section 3.4.)
Note. For details, contact with Heidenhain Corporation.
POINT
This linear encoder is of four-wire type. When using any of these encoder, set
parameter No.PC26 to "1
Load side encoder cable
1)
3)
2)
Load side encoder cable
3) Junction connector (This
should be prepared by
the customer.)
17-pin coupling (female)
291697-26
(manufactured by
Heidenhain Corporation)
" to select the four-wire type.
Linear encoder
LC491M or LC192M
4) Output cable
Cable
4) 337 439-
m
(manufactured by
Heidenhain
Corporation)
(This should be
prepared by the
customer.)
3 - 16
Output cable
LC491M LC192M
4) 343 421-
m
(manufactured by
Heidenhain
Corporation)
(This should be
prepared by the
customer.)