Mitsubishi Electric MR-J3-B-RJ006 Instruction Manual page 74

3. LOAD SIDE ENCODER
(c) For ST741A or ST743A
1) Cable structure
Prepare a cable based on the following structure diagram.
For the signal adjustment and confirmation, connect the following equipments. (Note 2)
Software for
Personal computer
signal adjustment
When using an 1) Options manufactured by Mitutoyo Corporation (This should be prepared by
optional cable the customer.) (Note 1)
Part No.06ACF117A: 5m
Part No.06ACF117B: 10m
When producing a 2) Connector set MR-J3CN2
load side encoder (Option manufactured by
cable Mitsubishi Electric
Corporation)
(Refer to section 3.4.)
Note 1. For details, contact with Mitutoyo Corporation .
2. When mounting ST741A ST743A, a personal computer (with RS-232C port) for the signal adjustment and confirmation, and a
software and conversion unit for signal adjustment are required. For details, contact with Mitutoyo Corporation.
Servo amplifier
Load side encoder cable
CN2L
Conversion unit
Load side encoder cable
3) Junction connector (This should be
prepared by the customer.)
D-SUB (female) 15 Pin shell: HDAB-15S'
Plug case: HDA-CTH
(manufactured by HIROSE ELECTRIC
CO., LTD)
3 - 9
1)
2) 3)
Cable
Linear encoder
ST741A
Head cable
Head cable
Accessories for linear encoder
Cable length: 1m