About Incoming Rcfs; Rejecting Incoming Rcfs - Cisco Nexus 5000 Series Configuration Manual

Information About Fibre Channel Domains
SUMMARY STEPS
1. switch# configuration terminal
2. switch(config)# fcdomain fabric-name 20:1:ac:16:5e:0:21:01 vsan vsan-id
3. switch(config)# no fcdomain fabric-name 20:1:ac:16:5e:0:21:01 vsan vsan-id
DETAILED STEPS
Command or Action
Step 1 switch# configuration terminal
Step 2 switch(config)# fcdomain fabric-name
20:1:ac:16:5e:0:21:01 vsan vsan-id
Step 3 switch(config)# no fcdomain fabric-name
20:1:ac:16:5e:0:21:01 vsan vsan-id

About Incoming RCFs

You can configure the rcf-reject option on a per-interface, per-VSAN basis. By default, the rcf-reject option
is disabled (that is, RCF request frames are not automatically rejected).
The rcf-reject option takes effect immediately.
No fcdomain restart is required.
You do not need to configure the RFC reject option on virtual Fibre Channel interfaces, because these
Note
interfaces operate only in F port mode.

Rejecting Incoming RCFs

To reject incoming RCF request frames, perform this task:
SUMMARY STEPS
1. switch# configuration terminal
2. switch(config)# interface fc slot/port
3. switch(config-if)# fcdomain rcf-reject vsan vsan-id
4. switch(config-if)# no fcdomain rcf-reject vsan vsan-id
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide
32
Configuring Domain Parameters
Purpose
Enters configuration mode.
Assigns the configured fabric name value in the specified
VSAN.
Changes the fabric name value to the factory default
(20:01:00:05:30:00:28:df) in VSAN 3010.
OL-xxxxx-xx