Incoming Rcfs; Rejecting Incoming Rcfs - Cisco Nexus 6000 Series Configuration Manual

Fibre Channel Domains
Procedure
Step 1
Step 2
Step 3

Incoming RCFs

You can configure the rcf-reject option on a per-interface, per-VSAN basis. By default, the rcf-reject option
is disabled (that is, RCF request frames are not automatically rejected).
The rcf-reject option takes effect immediately.
No fcdomain restart is required.
Note You do not need to configure the RCF reject option on virtual Fibre Channel interfaces.

Rejecting Incoming RCFs

You can reject incoming RCF request frames.
Procedure
Step 1
Cisco Nexus 6000 Series NX-OS SAN Switching Configuration Guide, Release 6.x
10
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
fcdomain fabric-name 20:1:ac:16:5e:0:21:01
vsan vsan-id
Example:
switch(config)# fcdomain fabric-name
20:1:ac:16:5e:0:21:01 vsan 1
no fcdomain fabric-name 20:1:ac:16:5e:0:21:01
vsan vsan-id
Example:
switch(config)# no fcdomain fabric-name
20:1:ac:16:5e:0:21:01 vsan 1
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
Configuring Fibre Channel Domain Parameters
Purpose
Enters global configuration mode.
Assigns the configured fabric name value in
the specified VSAN. The VSAN ID ranges
from 1 to 4093.
Changes the fabric name value to the factory
default (20:01:00:05:30:00:28:df) in VSAN
3010. The VSAN ID ranges from 1 to 4093.
Purpose
Enters global configuration mode.
OL-27932-01