Yamaha XV1600A1999 Service Manual page 58

F Route the seat lock cable on the wire harness.
G Through the seat lock cable on the wireharness.
H Clamp the wireharness, seat lock cable to the
frame and the end of clamp is downward, Dont
clamp the fuel sender lead.
I The coupler under the wireharness.
J Clamp the wireharness, fuel sender lead and
seat lock cable with a locking tie and cut of the
end.
K Clamp the wireharness and battery negative
lead.
L Clamp the tail / brake light lead.
M Route the starter negative lead through the
guide of the battery box.
N Push the alarm coupler on the wireharness.
CABLE ROUTING
O Cover the sidestand switch lead, horn lead start-
er lead and pickup coil lead and then align the
clamp to the cover. Cover slit is inside.
P Clamp the sidestand switch lead, horn lead start-
er lead and pickup coil lead.
Q Clamp the horn lead starter lead with a band and
the cut the end of band. Locate the end of band to
upward.
R Clamp the starter lead.
S Clamp the rear brake light switch lead and recti-
fire / regulator lead.
T Clamp the wireharness.
U Clamp the speed sensor lead decompression
solelnoid lead pick up coil lead neutral switch
lead stator coil lead sidestand switch lead and
horn lead to the frame.
2-34
SPEC