Lock Washers/Plates And Cotter Pins - Yamaha XV1600A1999 Service Manual

IMPORTANT INFORMATION
EAS00023
LOCK WASHERS/PLATES AND COTTER
PINS
After removal, replace all lock washers/plates
1 and cotter pins. After the bolt or nut has been
tightened to specification, bend the lock washer
tabs and the cotter pin ends along a flat of the
bolt or nut.
EAS00024
BEARINGS AND OIL SEALS
1. Install bearings and oil seals so that the
manufacturer's marks or numbers are vis-
ible. When installing oil seals, lubricate the oil
seal lips with a light coat of lithium soap base
grease. Oil bearings liberally when installing,
if appropriate.
1 Oil seal
CAUTION:
Do not spin the bearing with compressed air
because this will damage the bearing sur-
faces.
1 Bearing
EAS00025
CIRCLIPS
Before reassembly, check all circlips carefully
and replace damaged or distorted circlips. Al-
ways replace piston pin clips after one use.
When installing a circlip 1 , make sure the
sharp-edged corner 2 is positioned opposite
the thrust 3 that the circlip receives.
4 Shaft
1-7
GEN
INFO