Checking The Valve Seats - Yamaha XV1600A1999 Service Manual

VALVES AND VALVE SPRINGS
6. Measure:
S valve stem runout
NOTE:
S When installing a new valve, always replace
the valve guide.
S If the valve is removed or replaced, always re-
place the oil seal.
EAS00240

CHECKING THE VALVE SEATS

The following procedure applies to all of the
valves and valve seats.
1. Eliminate:
S carbon deposits
2. Check
S valve seat
3. Measure:
S valve seat width a
a. Apply Mechanic's blueing dye (Dykem) b
b. Install the valve into the cylinder head.
c. Press the valve through the valve guide and
5-48
Out of specification ! Replace the valve.
Valve stem runout
0.01 mm
(from the valve face and valve seat)
Pitting/wear ! Replace the cylinder head.
Out of specification ! Replace the cylinder
head.
Valve seat width
Intake: 0.9
<Limit>: 2.0 mm
Exhaust: 0.9
<Limit>: 2.0 mm
onto the valve face.
onto the valve seat to make a clear impres-
sion.
ENG
1.1 mm
1.1 mm