Yamaha XV1600A1999 Service Manual page 201

HANDLEBAR
8. Install:
S handlebar grip
a. Apply a thin coat of rubber adhesive onto the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
9. Install:
S throttle grip
10. Connect:
S throttle cable
11. Install:
S right handlebar switch
NOTE:
Align the projection a on the right handlebar
switch with the hole b in the handlebar.
12. Install:
S brake master cylinder
S brake master cylinder holder
NOTE:
S Install the brake master cylinder holder with
the "UP" mark facing up.
S Align the end of the brake master cylinder
holder with the punch mark a in the handle-
bar.
4-71
CHAS
10 Nm (1.0 mSkg)
E