Enabling Disruptive Load Balancing; Verifying Npv - Cisco Nexus 5000 Series Configuration Manual

Configuring N Port Virtualization
If a server interface is already mapped to an NP uplink, you should include this mapping in the traffic
Note
map configuration.
To configure a traffic map, perform this task:
SUMMARY STEPS
1. switch# configure terminal
DETAILED STEPS
Command or Action
Step 1 switch# configure terminal

Enabling Disruptive Load Balancing

If you configure additional NP uplinks, you can enable the disruptive load-balancing feature to distribute the
server traffic load evenly among all the NP uplinks.
To enable disruptive load balancing, perform this task:
SUMMARY STEPS
1. switch# configure terminal
2. switch(config)# npv auto-load-balance disruptive
3. switch (config)# no npv auto-load-balance disruptive
DETAILED STEPS
Command or Action
Step 1
switch# configure terminal
Step 2
switch(config)# npv auto-load-balance disruptive
Step 3
switch (config)# no npv auto-load-balance disruptive

Verifying NPV

To display information about NPV, perform the following task:
OL-27583-01
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
Purpose
Enters global configuration mode.
Purpose
Enters configuration mode on the NPV.
Enables disruptive load balancing on the switch.
Disables disruptive load balancing on the switch.
Verifying NPV
63