Displaying Vsan Trunking Information - Cisco Nexus 5000 Series Configuration Manual

Displaying VSAN Trunking Information

Command or Action
Step 2
switchport trunk allowed vsan vsan-id - vsan-id
Example:
switch(config-if)# switchport trunk allowed vsan 35-55
Step 3 switchport trunk allowed vsan add vsan-id
Example:
switch(config-if)# switchport trunk allowed vsan add 40
Step 4 no switchport trunk allowed vsan vsan-id - vsan-id
Example:
switch(config-if)# no switchport trunk allowed vsan 61-65
Step 5 no switchport trunk allowed vsan add vsan-id
Example:
switch(config-if)# no switchport trunk allowed vsan add
40
Displaying VSAN Trunking Information
The show interface command is invoked from the EXEC mode and displays VSAN trunking configurations
for a TE port. Without any arguments, this command displays the information for all of the configured interfaces
in the switch.
The following example shows how to display the trunk mode of a Fibre Channel interface:
switch# show interface fc3/3
fc3/3 is up
...
The following example shows how to display the trunk protocol of a Fibre Channel interface:
switch# show trunk protocol
Trunk protocol is enabled
The following example shows how to display the VSAN information for all trunk interfaces:
switch# show interface trunk vsan 1-1000
fc3/1 is not trunking
...
fc3/11 is trunking
...
san-port-channel 6 is trunking
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
92
Hardware is Fibre Channel, SFP is short wave laser w/o OFC (SN)
Port WWN is 20:83:00:0d:ec:6d:78:40
Peer port WWN is 20:0c:00:0d:ec:0d:d0:00
Admin port mode is auto, trunk mode is on
Belongs to san-port-channel 6
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
Configuring VSAN Trunking
Purpose
Changes the allowed list for the specified
VSAN range.
Expands the specified VSAN to the new
allowed list.
Deletes the specified VSAN range.
Deletes the expanded allowed list.
OL-27583-01