Configuring Retransmitting Intervals; About Disabling Fspf For Specific Interfaces; Disabling Fspf For Specific Interfaces - Cisco Nexus 5000 Series Configuration Manual

FSPF Interface Configuration
This value must be the same on the switches on both ends of the interface.
Note

Configuring Retransmitting Intervals

You can configure the FSPF retransmit time interval.
SUMMARY STEPS
1. configure terminal
2. switch(config)# interface fc slot/port
3. fspf retransmit-interval value vsan vsan-id
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2 switch(config)# interface fc slot/port
Step 3
fspf retransmit-interval value vsan vsan-id
Example:
switch(config-if)# fspf retransmit-interval
10 vsan 25

About Disabling FSPF for Specific Interfaces

You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and TE
ports. This default can be disabled by setting the interface as passive.
FSPF must be enabled at both ends of the interface for the protocol to work.
Note

Disabling FSPF for Specific Interfaces

You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and TE
ports. This default can be disabled by setting the interface as passive.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
188
Configuring Fibre Channel Routing Services and Protocols
Purpose
Enters global configuration mode.
Configures the specified interface, or if already configured,
enters configuration mode for the specified interface.
Specifies the retransmit time interval for unacknowledged
link state updates in the specified VSAN. The default is 5
seconds.
OL-27583-01