Configuring Zone Merge Control Policies - Cisco Nexus 5000 Series Configuration Manual

Configuring and Managing Zones
• If the protocol versions are the same, then the zone policies are compared. If the zone policies differ,
• If the zone merge options are the same, the comparison is implemented based on the merge control

Configuring Zone Merge Control Policies

You can configure merge control policies.
SUMMARY STEPS
1. configure terminal
2. zone merge-control restrict vsan vsan-id
3. no zone merge-control restrict vsan vsan-id
4. zone commit vsan vsan-id
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
zone merge-control restrict vsan vsan-id
Example:
switch(config)# zone merge-control restrict vsan 24
Step 3 no zone merge-control restrict vsan vsan-id
Example:
switch(config)# no zone merge-control restrict vsan
33
Step 4 zone commit vsan vsan-id
Example:
switch(config)# zone commit vsan 20
OL-27583-01
the ISL is isolated.
setting.
◦ If the setting is restrict, the active zone set and the full zone set should be identical. Otherwise, the
link is isolated.
◦ If the setting is allow, the merge rules are used to perform the merge.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
Purpose
Enters global configuration mode.
Configures a restricted merge control setting for
this VSAN.
Defaults to using the allow merge control setting
for this VSAN.
Commits the changes made to the specified VSAN.
Enhanced Zoning
161