Configuring Dhchap Aaa Authentication; Displaying Protocol Security Information - Cisco Nexus 5000 Series Configuration Manual

Configuring DHCHAP Authentication
Command or Action
Step 2
fcsp timeout timeout
Example:
switch(config)# fcsp timeout 60
Step 3 no fcsp timeout timeout
Example:
switch(config)# no fcsp timeout 60

Configuring DHCHAP AAA Authentication

You can configure AAA authentication to use a RADIUS or TACACS+ server group. If AAA authentication
is not configured, local authentication is used by default.

Displaying Protocol Security Information

Use the show fcsp commands to display configurations for the local database.
The following example shows how to display the DHCHAP configuration for the specified interface:
switch# show fcsp interface fc2/4
fc2/4
The following example shows how to display DHCHAP statistics for the specified interface:
switch# show fcsp interface fc2/4 statistics
The following example shows how to display the FC-SP WWN of the device connected to the specified
interface:
switch# show fcsp interface fc2/1 wwn
The following example shows how to display the hash algorithm and DHCHAP groups configured in the
switch:
switch# show fcsp dhchap
The following example shows how to display the DHCHAP local password database:
switch# show fcsp dhchap database
Use the ASCII representation of the device WWN to configure the switch information on RADIUS and
TACACS+ servers.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
248
fcsp authentication mode:SEC_MODE_ON
Status: Successfully authenticated
Configuring FC-SP and DHCHAP
Purpose
Configures the reauthentication timeout to the specified
value. The unit is seconds.
Reverts to the factory default of 30 seconds.
OL-27583-01