Table of Contents
Advertisement
5 Installation
5-3-2
Wire the Power Connector
This section describes how to wire the power connector.
Precautions for Safe Use
• Do not perform a dielectric strength test.
• Do not let metal particles enter the product when preparing the panel. Do not allow wire clip-
pings, shavings, or other foreign material to enter any product. Otherwise, the product burn-
ing, failure, or malfunction may occur. Cover the product or take other suitable countermeas-
ures, especially during wiring work.
Additional Information
• The selected conductor size must match with the used maximum power supply capacity or an
overcurrent protection device must be used.
• The used wires and the overcurrent protection device must meet the applicable national
standards. Standards are:
• NEC (National Electric Code)
• CEC (Canadian Electrical Code)
• international applicable standards
• Refer to 4-1-2 General Electrical Specifications on page 4 - 3 for electrical specifications.
Power Connector Wiring Materials
Use the power supply connector that was supplied to connect the power supply to the Industrial Moni-
tor.
• Select power supply conductors with consideration to the voltage drop and heat generation for the
cable length at the installation environment.
• Always use twisted wires to minimize the occurrence of electrical disturbance.
• Recommended power supply conductor sizes for the connector are provided in the table.
Solid conductor
Flexible conductor
Flexible conductor, with ferrule and no plastic sleeve
Flexible conductor, with ferrule and plastic sleeve
Minimum AWG according to UL/CUL
Maximum AWG according to UL/CUL
• Power Supply Connector
5 - 24
Wire type
Conductor cross-section
2
0.5 to 2.5 mm
24
13
NY-series Industrial Monitor User's Manual (W554)
Advertisement
Table of Contents
