Table of Contents
Advertisement
DC Power Supply
The OMRON S8VK-series power supply is recommended for use with the Industrial Monitor.
Additional Information
• Refer to 2-4-4 Power Supply on page 2 - 13 for more information.
• Refer to 4-1-2 General Electrical Specifications on page 4 - 3 for power consumption details.
Power Connector Wiring Procedure
Use the following procedure to wire the power connector.
1
Remove the sheath from the power supply wires.
Precautions for Safe Use
Observe the following to precautions to prevent broken wires.
• When you remove the sheath, be careful not to damage the conductor.
• Connect the conductor without twisting the wires.
• Do not weld the conductors. Doing so may cause the wires to break with vibration.
2
Insert a screwdriver in the small orange groove above the cable opening
driver
1
opening
Pin
1
2
3
Remove the screwdriver.
Do not apply stress to the cable after you have connected the wires.
NY-series Industrial Monitor User's Manual (W554)
to unlock the cable entry and then push the wire all the way to the back of the cable
.
2
1
2
24 VDC
0 VDC
7 mm
1
2
Description
5 Installation
. Push the screw-
1
5 - 25
5
Advertisement
Table of Contents
