Table of Contents
Advertisement
5
Boiler block assembly
Fitting the temperature sensor and communication
cable
V Press the cable grip [1] into the holes provided in the
bottom crossmember.
V Lay the cables over the thermal insulation.
V Insert the cables into the strain relief. The clear length
must be 70 to 75 cm.
V Secure the cables via the strain relief using two self-
tapping screws.
The cables must always be laid as shown, regardless of
whether the door opens to the right or to the left.
Fitting the mains power cable
V Fit the cable clip [1].
V Insert mains supply cable into the cable clip [1].
The mains power cable must always be laid as shown,
regardless of whether the door opens to the right or to the
left.
Connecting cables to the SAFe
V Connect temperature sensor [2], communication [3]
and mains power cables to the SAFe [4] as shown in
the wiring diagram (
32
Logano G225/Logano plus GB225 - We reserve the right to make any changes due to technical modifications.
burner documentation).
Fig. 39 Fitting the temperature sensor and communica-
tion cable
1
Strain relief
2
Temperature sensor and communication cable
A
Push the strain relief into the holes of the lower tie bar
B
Insert and secure the cables
4
Fig. 40 Fitting the mains power cable
1
Cable clip for mains power cable
2
Temperature sensor lead
3
Communication cable
4
SAFe
A
B
6 720 615 876-39.1RS
1
6 720 615 876-40.1RS
2
1
2
3
Hide quick links:
Advertisement
Table of Contents
