Fitting the side panels
The side panel installation for the left-hand and right-hand
side is identical (in this example on the right-hand side
panel).
V Push the snap nut onto the angled sheet steel of the
side panel, until it locks into the hole provided.
V Slot the side panel into the end flange of the bottom
crossmember [1].
V Slightly lift the side panel.
V Hook the top cutout in the side panel over the top
crossmember [A].
V Hook the rear part of the side panel over the protruding
hook [B].
Logano G225/Logano plus GB225 - We reserve the right to make any changes due to technical modifications.
Boiler block assembly
Fig. 41 Fitting the snap-on nut (in this example on the
right-hand side panel)
Fig. 42 Pushing the front lower side panel into place
1
Angled part of the lower tie bar
Fig. 43 Hooking-in the side panel
A
Top crossmember
B
Protruding hook
5
6 720 615 876-41.1RS
1
B
A
6 720 615 876-43.1RS
33