Mitsubishi QJ71LP21 Reference Manual page 383

APPENDIX
No. Name
2
Data linking stop request
SW004A
station
(74)
2
SW004B Host CPU status
(75)
2
Data linking start status
SW004D
(host)
(77)
2
Data linking stop status
SW004F
(host)
(79)
2
Data linking start status
SW0051
(entire system)
(81)
2
Data linking stop status
SW0053
(entire system)
(83)
SW0054
Parameter information
(84)
2: Valid only when SB0047 is off. When it turns on (error), the last data are retained.
App - 15
Table 2 Link special register (SW) list (Continued)
Description
Stores the station that stopped the host data linking. (Valid when
the SW0049 is 1.)
b15 b14 to b7 b6 b5 b4 b3
SW004A 0 to 0
0: Station number designated
1: All stations designated
b0 to b6 store 7D if a data link stop request is received from the
H
remote master station/multiplexed remote master station.
Indicates the CPU status of the host.
0 : Normal
Other than 0 : Abnormal (For the error codes, see Section
8.3 or the "Error Code" chapter of QCPU
User's Manual (Hardware Design,
Maintenance and Inspection).)
Stores the result of the data linking start.
0 : Normal
Other than 0 : Abnormal (see the error codes in Section 8.3)
Stores the result of the data linking stop.
0 : Normal
Other than 0 : Abnormal (see the error codes in Section 8.3)
Stores the result of the data linking start.
0 : Normal
Other than 0 : Abnormal (see the error codes in Section 8.3)
Stores the result of the data linking stop.
0 : Normal
Other than 0 : Abnormal (see the error codes in Section 8.3)
At the PLC to PLC network.
Stores the parameter information.
(When the SB0054 and SB0055 are off.)
b15 b14 to b2 b1 b0
0 to 0
MELSECNET/H
0: Not designated
1: Designated
(When the SB0055 is on.)
b15 b4 b3
0 to 0 0 1
When remote I/O net
Stores the parameter information.
(When the SB0054 and SB0055 are off.)
to
b15 b3
0 to 0
b2 b1 b0
0: Host 1 to 64: Station number
Type
00: Use only common parameters
01: Common parameters + station
specific parameters
10: Use only default parameters
11: Default parameters + station
specific parameters
b2 b1 b0
= 0F : Parameter error
1 1 1
H
Check the error code in the SW055.
b2 b1 b0
0 0
Intelligent function
module parameter
0: No
1: Yes
MELSEC-Q
Use permitted/prohibited
Remote
Control Normal
master
station station
station
Optical Coaxial Optical Coaxial Optical Coaxial Optical Coaxial
Remote I/O
station
App - 15