Mitsubishi QJ71LP21 Reference Manual page 201

7 APPLICATION FUNCTIONS
7 - 35
R master
cyclic trans
control
Station 2
baton path
status
Station 2
cyclic
transmission
In the timer constant K , set the following value.
Baton path status
(T0, T3)
Cyclic transmission status
Parameter communication status
(T1, T2, T4)
Reason: The above value should be set to prevent control from being stopped if the
network has detected an instantaneous fault due to the cable, noise and so
forth.
4 times and 3 times are given as guidelines.
Continuation processing program used when multiplexed remote
master station fails
Program for communication with remote I/O station No. 2
(Sequence scan time
(Sequence scan time
MELSEC-Q
4) or more
3) or more
7 - 35