Table of Contents
Advertisement
WARNING
Always read and observe the warnings before completing any work in the
■
engine compartment
» page
281.
Accidents can be caused if the road in front of the vehicle is not suffi-
■
ciently illuminated and the vehicle cannot or can only be seen with difficulty
by other road users.
H7 and H8 bulbs are pressurised and may burst when changing the bulb -
■
risk of injury! We therefore recommended wearing gloves and safety
glasses when changing a bulb.
CAUTION
Do not take hold of the glass bulb with naked fingers (even the smallest
■
amount of dirt reduces the working life of the light bulb). Use a clean cloth,
napkin, or similar.
The cap of the filament bulb must always be seated correctly in the head-
■
light, otherwise this may allow water and debris to enter the headlight - risk of
damage to the headlights.
Note
We recommend that a box of replacement bulbs always be carried in the vehi-
cle.
Bulb arrangement in the halogen headlights
Read and observe
and
Bulb arrangement
» Fig. 375
Low beam
A
Flashing
B
312
Do-it-yourself
Fig. 375
Left headlight
on page 312 first.
Main beam and side lights
C
Fog lights
D
Change light bulb for main beam light and parking lights
Fig. 376 Changing the bulb for the main beam
Fig. 377 Change the light bulb for the parking light
Read and observe
and
Remove / insert the bulb for main beam
›
Remove the protective cap
C
›
Turn the holder with the bulb in the direction of the arrow
›
Remove the holder with the bulb in the direction of arrow
›
Remove the bulb from the holder in the direction of the arrow
›
Insert a new bulb into the holder so that the lug
the groove on the bulb.
›
Insert the holder with the new bulb into the headlight in the opposite direc-
tion to the arrow
.
2
on page 312 first.
» Fig. 375
on page 312.
» Fig.
1
.
2
3
on the holder snaps into
A
376.
.
Advertisement
Table of Contents
