Table of Contents
Advertisement
Swinging in and out the tow bar
Fig. 321 Ball rod: swing out
Fig. 322 Ball rod: swing in
Read and observe
on page 264 first.
The pivotable tow bar cannot be removed. Its correct latching in both posi-
tions is indicated by a warning light.
Swing out the tow bar
›
Pull the switch in the direction of arrow
of the switch may be different depending on equipment fitted
bar swings out in the direction of arrow
switch flashes.
›
Press the tow bar in direction of arrow
The indicator light
inside the switch illuminates,
» Fig. 321
(the installation location
1
»
. The tow
and the indicator light
in in the
2
until it audibly clicks into place.
3
Swivel tow bar
No trailer or other accessory is connected to the tow bar. A socket or adapter
may not be plugged into the 13-pin socket.
›
Pull the switch in the direction of arrow
locked and the indicator light
›
Swing in the tow bar under the bumper in the direction of arrow
audibly clicks into place. The indicator light
Check latching
If the tow bar is incorrectly locked, the warning light inside the switch flashes
red, after the ignition is switched on an acoustic signal is sounded and an ap-
propriate message appears in the instrument cluster.
WARNING
Take care with the towing device - it may cause injury.
■
When swinging out the ball rod away from the central area of the rear
■
bumper, there is a danger of injury to the legs.
Do not manipulate the switch while a trailer or another accessory is cou-
■
pled to the tow bar. The tow bar could come loose - risk of accident and
injury.
If the indicator light it supplied the switch does not light or flashes, or if
■
the tow bar can not engage, then do not use this. Seek help from a special-
ist garage.
Note
When not using the towing device, always swing the tow bar under the bump-
er.
» Fig. 322
. The tow bar is un-
4
inside the switch flashes.
inside the switch illuminates,
Towing device and trailer
until it
5
265
Advertisement
Table of Contents
