Table of Contents
Advertisement
Retrieving the saved setting
›
With the ignition off and the driver's door open-press- the desired memory
button B.
›
In other cases (e.g. if the ignition is switched on or the driver's door closed),
hold the button.
Stopping the ongoing adjustment
›
Press any button on the seat that is to be set. The driver's seat can also be
stopped by pressing the button on the radio-operated key.
Note
Every time you save new seat and exterior mirror settings for driving forwards,
you must also save the front passenger mirror setting for reversing again.
Memory function of the remote control key
Applies to vehicles that do not have the personalisation function.
Read and observe
on page 86 first.
Every time the vehicle is locked, the driver´s seat and exterior mirror settings
are saved and assigned to the key with which the vehicle was locked.
After the following unlocking of the vehicle with the same key and opening the
driver's door, the driver´s seat and exterior mirrors that are saved to this key
will be adopted.
This function can be used in Infotainment in the menu
tivated/deactivated).
Storing front passenger´s exterior mirror settings for reversing
The function for lowering the front passenger's mirror area during reversing
can be activated in Infotainment in the menu
›
Unlock the vehicle with the remote control key and switch on the ignition.
›
Turn the rotary knob for the exterior mirror control to the position for the
front passenger mirror area
» page
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position.
›
Disengage reverse gear. The adjusted position of the exterior mirror is stored
in the remote control key memory.
88
Operation
/ → → Seats (ac-
/ → → Mirrors and wipers.
85.
Stopping the ongoing adjustment
›
Press any button on the driver's seat or the button on the remote control
key.
Folding front passenger seat
Read and observe
on page 86 first.
The front passenger seat can, (depending on vehicle equipment fitted), be fol-
ded forward into a horizontal position.
›
To fold down, pull the lever in direction of arrow
the direction of arrow
» Fig.
2
snap into place.
›
To fold up, pull the lever in direction of arrow
against the direction of arrow
into place.
›
Check this by pulling on the seat and on the seat backrest.
WARNING
If the seat backrest is folded down, only the seat behind the driver´s seat
■
can be used to transport passengers.
The front passenger airbag should be switched off when transporting ob-
■
jects on the seat which was folded forwards
Do not adjust the seat backrest while driving - it can cause injury and ac-
■
cidents!
Fig. 90
Folding the front passenger seat
forward
, fold the seat backrest in
1
90. The locking mechanism must audibly
, fold back the seat backrest
1
. The locking mechanism must audibly snap
2
» page
32.
Advertisement
Table of Contents
